Adhesive mixture “STOLIT S” is used for gluing polystyrene foam and mineral wool plates, flooding the reinforcing mesh on top of the insulation when insulating buildings using the “light” method.

To immerse the reinforcing mesh on a polystyrene or mineral wool plate, a thin layer of the ready mixture of 1-2 mm is applied with a spatula, the necessary piece of mesh is applied, straightened and pressed in several places. Then a second layer of the same thickness is applied, while it is necessary to ensure that the reinforcing mesh does not protrude through its surface. Smooth the second layer carefully.


Preparation of adhesive solution:

Add the contents of the bag to 6.5-7.0 liters of clean cold water, mix intensively until a homogeneous mixture without lumps is obtained. Mix again after 5 minutes. The finished solution should be used within 2-3 hours. After finishing “STOLIT S”, in order to improve the operational properties of the finish layer, it is recommended to additionally apply a deep penetration primer TM “STOLIT”.


Technical data:

Composite mixture of cement, mineral fillers and polymer modifiers
Dough proportions 0.26 l for water per 1 kg of mixture
Working time with the finished solution up to 3 hours
Base temperature from +5 °С to +35 °С
Film formation time more than 20 minutes
Time for amendments within 25 minutes
Temperature stability from -30 °C to +70 °C
Expenses 3-5 kg/m2 for “Stolit C”

 

Buy glue “STOLIT S”